ar0500d2011us

Remove, install hydraulic valve clearance compensating elements

Type ar · topic 05.00 · version 0100 · 2007-09-13

Applies to: ENGINE 272.979 in MODEL 906

Where it sits

Function group 1 Engine › 05 Engine timing › 05.00 General — Series 906

EinPAS 15 Engine › 15.17 Engine timing › 15.17.30 Valve train — Series 906

Also applies to engines/gearboxes: 272 979

AR05.00-D-2011US

Remove, install hydraulic valve clearance compensating elements

29.8.07

ENGINE 272.979 in MODEL 906

Remove, install hydraulic valve clearance compensating elements

P05.00-2048-02

1 Roller drag lever

2 Compensating element

3 Clamp

Remove/install

1

Remove the camshaft of the compensation element (2) to be removed

AR05.20-D-6992US

2

Take out cam follower (1) with compensation element (2)

When removing several compensation elements (2), ensure that the roller-type cam followers (1) with the compensation elements (2) that were not replaced are reinstalled at the previous fitting point. If required, mark the roller-type cam followers (1) according to the compensation elements (2).

Installation: Oil roller-type cam follower (1) and compensation element (2).

3

Dismount clamp (3) by hand and remove compensation element (2) from cam follower (1)

4

Install in the reverse order

5

Check engine oil level, correct if necessary

Check the engine oil level two minutes after switching off the engine.

The engine oil level must not be above the maximum mark. This can lead to engine damage.

The fill level markings on the oil dipstick are designed for an engine oil temperature of about 80 °C. Do not top up with any more oil for engine oil temperatures below this when filling the prescribed oil quantity.

Referenced documents