Replace rear crankshaft radial seal

AR03.20-P-3063RT

Replace rear crankshaft radial seal

14.4.05

 

Remove/install

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

1

Remove automatic transmission

AR27.10-P-0500RTA

2

Remove drive plate (3)

AR03.30-P-8001RT

3

Remove end cover (1)

 The crankshaft radial sealing ring (2) at the end cover (1) cannot be exchanged. This end cover (1) is fitted at the factory and therefore must be replaced.

AR01.40-P-8913RT

 Crankshaft radial sealing ring (2) must not be pushed out when the end cover (1) is fitted.

4

Remove crankshaft radial seal (2)

 Installation: First of all install the end cover (1), then install the crankshaft radial sealing ring (2):

Install crankshaft radial seal

AR03.20-P-3063-01B

 Installation tool

*111589084300

5

Install in the reverse order

6

Check engine oil level and correct if required.

 Vehicle must be horizontal and standing on its wheels. Measuring errors can occur if this requirement is not observed.

AR18.00-P-3035-01GZ

 Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near engine

Secure vehicle to prevent it from moving.
Wear closed and snug-fitting work clothes.
Do not grasp hot or rotating parts.

AS00.00-Z-0005-01A

7

Conduct engine test run and check the engine for oil leaks

 In the event of oil loss determine and eliminate cause, otherwise malfunctions, transmission damage, and serious environmental pollution may occur.