1 | Cover |
2 | Expansion rivet |
3 | Crankshaft belt pulley |
4 | Center bolt |
P01.00-2952-04
5 | Inspection light |
6 | Endoscope |
P01.00-2953-04
| Remove/install | ||
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
1 | Raise vehicle with vehicle lift until the cover (1) is accessible. | ||
2 | Remove expansion rivets (2) and remove cover (1). | ||
3 | Lower vehicle with vehicle lift. | ||
4 | Remove injector of cylinder to be inspected with light probe. | ||
5 | Insert a suitable hose through injector well into corresponding cylinder and crank engine at center bolt (4) of crankshaft belt pulley (3) in direction of engine rotation until piston of cylinder to be checked is at bottom dead center. | ||
6 | Connect inspection light (5) to endoscope (6) and insert inspection light (5) through injector well into cylinder to be checked. | Endoscope | |
| Check | ||
7 | Check cylinder barrel, piston crown, and valves. | ||
General information on inspecting cylinder walls | |||
In the case of visible cylinder wear the cylinder barrel is roughened and the honing marks are no longer visible. | |||
In case of doubt: | |||
| |||
Remove cylinder head. | |||
8 | Perform check of additional cylinders in same manner. | ||
9 | Install in the reverse order. |
Referenced documents
- ah0100p030001a General information on inspecting cylinder walls
- ar0130p5800mcd Remove/install cylinder head
- ar0716p1000mcd Remove/install injectors
- as0000z001001a Risk of death caused by vehicle slipping or toppling off of the lifting platform.