1 | Expanding rivets |
2 | Cover |
3 | Center bolt |
4 | Crankshaft belt pulley |
P01.00-2995-06
R4 | Spark plugs |
P15.10-2222-11
| Remove/install | ||
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
1 | Lift vehicle using the vehicle lift until the rear wheels can be turned freely. | ||
2 | Remove expansion rivets (1) and remove cover (2). | ||
3 | Remove spark plugs (R4). | ||
| |||
4 | Insert a suitable hose through spark plug threaded bore into corresponding cylinder and crank engine at center bolt (3) of crankshaft belt pulley (4) in direction of engine rotation until piston of cylinder to be checked is at bottom dead center. | ||
5 | Connect inspection light to endoscope and insert inspection light through spark plug threaded bore into cylinder to be checked. | Endoscope | |
| Check | ||
6 | Check cylinder barrel, piston crown, and valves. | ||
General information on inspecting cylinder walls | |||
In the case of visible cylinder wear the cylinder barrel is roughened and the honing marks are no longer visible. | |||
In case of doubt: | |||
| |||
Remove cylinder head. | |||
7 | Perform check of additional cylinders in same manner. | ||
8 | Install in the reverse order. |
Referenced documents
- ah0100p030001a General information on inspecting cylinder walls
- ap1510p1580mcc Replace spark plugs
- ar0130p5800mcc Remove/install cylinder head
- as0000z001001a Risk of death caused by vehicle slipping or toppling off of the lifting platform.