G72.16-A000-79
1 | Door button | 6 | Emergency release lever | |
2 | Fuse | A | Test point (200 mm below top edge of door) | |
3 | Emergency release lever | B | Test point (1000 mm above entrance) | |
4 | Fuse | C | Test point (any point between test points (B, D)) | |
5 | Lead seal | D | Test point (150 mm above entrance) |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Check automatic reversing function in closing direction | |||
1 | Park vehicle on level surface, operate parking brake and switch on ignition. | Battery voltage at least 12 V. | |
2 | Using the test equipment, check the automatic reversing function during the closing process at test points (A to D). | ||
| Testing supplies for door reversing system | ||
To do so, open sliding door using door button (1) and close again. | |||
If the sliding door does not move back to the opening position, | |||
| |||
determine cause and correct. | |||
After obtaining special order. | |||
3 | Close sliding door using door button (1). | ||
Check automatic reversing function in opening direction | |||
4 | Hold sliding door firmly during opening procedure. | Open sliding door using door button (1). | |
If the sliding door does not remain stationary, | |||
| |||
determine cause and correct. | |||
After obtaining special order. | |||
5 | Close sliding door using door button (1). | ||
Check interior emergency release | |||
6 | With sliding door closed, pull emergency release lever (6) in downward direction until it engages. | With the ignition switched on and the emergency release actuated, a warning tone is activated. | |
7 | Open sliding door by hand. | If sliding door cannot be opened by hand, | |
| |||
determine cause and correct. | |||
After obtaining special order. | |||
8 | Close sliding door by hand. | ||
9 | Push retainer (4) and move back emergency release lever (6). | ||
10 | Fit a new lead seal (5). | If the vehicle is outside Germany, the valid regulations of the relevant country must be observed. | |
Check exterior emergency release | |||
11 | Pull emergency release lever (3) in upward direction until it engages. | If the driver's door is locked, the emergency release lever (3) is blocked. | |
12 | Open sliding door by hand. | If sliding door cannot be opened by hand, | |
| |||
determine cause and correct. | |||
After obtaining special order. | |||
13 | Close sliding door by hand. | ||
14 | Push retainer (2) and move back emergency release lever (3). | ||
Check locking of sliding door while vehicle is in motion | |||
15 | Move vehicle at a speed of approx. 10 km/h. | Only perform the test on cordoned-off site, not on public roads. | |
16 | Operate door button (1). | The sliding door must remain closed. | |
If the sliding door opens, | |||
| |||
determine cause and correct. | |||
After obtaining special order. |
Referenced documents
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.
- wf5850d724001ts Testing supplies for door reversing system