Retrofit FleetBoard control unit

AN82.85-W-0100E

Retrofit FleetBoard control unit

13.1.16

Model

967

with code J9L (Pre-installation for FleetBoard for J3J)

Retrofitting code J3J (New FleetBoard vehicle computer with DTCO driver card)

1

Assembly frame

A30a

FleetBoard® control unit

Shown on model 967 with code F2U (ClassicSpace)

1

Assembly frame

2

Blind

3

Electrical wiring harness

4

Electrical connectors

5

Antenna lines

6

Retaining clips

A30a

FleetBoard® control unit

Shown on model 967 with code F2V (BigSpace)

1

Assembly frame

2

Blind

3

Electrical wiring harness

4

Electrical connectors

5

Antenna lines

6

Retaining clips

A30a

FleetBoard® control unit



Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A



Install

1

Insert FleetBoard® control unit (A30a) into assembly frame (1)

 Ensure that FleetBoard® control unit (A30a) engages correctly in assembly frame (1).

2

Unclip cover (2) from device installation frame

3

Remove electrical wiring harness (3) from device installation frame

4

Enable FleetBoard® telematics platform in vehicle



AZ82.85-W-1000-11NA

 After enabling, disconnect multiplexer from diagnostic connector.

5

Switch off ignition

6

Connect electrical connectors (4) and antenna lines (5) of electrical wiring harness (3) to FleetBoard® control unit (A30a)

 The electrical connectors (4) and antenna lines (5) are coded and cannot be improperly connected.

7

Insert FleetBoard® control unit (A30a) together with assembly frame (1) into device installation frame

 Ensure that retaining clamps (6) of assembly frame (1) engage correctly in device installation frame.

8

Install cover (2)

9

Connect diagnostic system, start XENTRY and perform quick test

 There must be no fault codes in the control units being updated. If necessary, process any fault codes in other control units, subject to separate repair order.

10

End XENTRY, disconnect diagnostic system

11

Fill out FleetBoard® initial startup form and send by fax



FleetBoard initial startup, form

OF82.85-W-3000-02B

 The FleetBoard® administrator will establish contact after receiving the fax to log the vehicle into the FleetBoard® server.

Update Vehicle Documentation (VeDoc)

12

Enter code J3J (New FleetBoard vehicle computer with DTCO driver card) via VeDoc in online vehicle data card

13

Attach note "FleetBoard® vehicle computer retrofitted as per AN82.85-W-0100E" under field organization texts to design group 82

Parts ordering note

Part no.

Designation

Quantity

A 960 446 03 60

Telematics electronics parts kit TP5 EU

1