AR42.10-B-0600C | Remove/install brake carrier with brake caliper | 12.02.16 |
Vehicle 688 with Cumbustion engine 374.905, 374.951, 374.990, 374.994, 374.950, 374.980, 374.984, 374.953, 374.986, 374.988, 374.991, 374.993, 374.996, 374.907, 374.989, 374.952, 374.977
Vehicle 979.0 with Cumbustion engine 612.983
B42.10-0463-11
1 Bolts
2 Support
| Remove and install | ||
| Indications related to the repair in the brake system | ||
1 | Park the vehicle on a flat and leveled location | ||
Danger | Risk of death by the vehicle slipping or tilting from the lift | Position the vehicle in a proper lift so that the wheels from the front, rear, drive and driven axles remain safely supported in the lift's support plates, in the lifting points determined by the vehicle's manufacturer. | |
Support the vehicle on easels, disposed under the chassis, in both sides, so that it is possible to disassemble the wheels and perform the works on the brake with safety | |||
2 | Remove the brake pads from the front axle | ||
Attention | Safety instructions regarding the brake fluid | ||
3 | Disassemble the brake flexible piping and close it | Use a proper plug. | |
Collect the brake fluid in a proper container and dispose it ecologically. The used brake fluid can not be reused. | |||
4 | Make it flow out from the brake caliper | Release the brake piping, turn it downward and open the bleeder. Then, put a plug to close the hole. | |
5 | Release the bolts (1) and remove the supports (2) with the brake caliper | Install: Replace the bolts (1) and apply the specified torque. | |
| |||
6 | Clean the support supporting surface (2) in the axle | ||
7 | Install in reverse order of the operations | ||
8 | Bleed the brake system | Vehicles 688.1 | |
Vehicles 979.0 | |||
9 | Check the service brake system tightness, operation and efficiency |
Front axle brake caliper