T42.15-0014-11
Figure 1
T42.15-0013-11
Figure 2
1 Brake caliper
2 Brake carrier
T42.15-0012-11
Fig. 3
1 Brake caliper
2 Brake carrier
T42.15-0015-01
Fig. 4
3 Knorr part number
4 Production period
| Remove/Install | ||
1 | Remove wheel | ||
2 | Remove brake linings | ||
3 | Screw back thrust piece against stop | ||
4 | Pull brake caliper as far as possible toward outside of vehicle (Figure 1) | ||
5 | Press brake caliper in direction of brake carrier on elastomer bearing | ||
| Measure | ||
6 | Measure distance (a) between brake caliper (1) and brake carrier (2) (Figure 2) | ||
7 | Press brake caliper away from brake carrier on elastomer bearing (see arrow Figure 3) and determine dimension (b) | The difference between the two measurements is the bearing play in the elastomer bearing. If it is greater than 3 mm: | |
Replace elastomer bearing. | |||
| Remove/Install | ||
8 | Determine repair version with model plate on Knorr brake caliper | Knorr brake model plate (Figure 4): Knorr part number (3), for example: Z0021242AT. Production period (4), for example: A02382, year 2002 (02) in CW 38. | |
9 | Install repair kit | Version 1 (production period up to 09/98) | |
Version 2 (production period 10/98 to 10/01) | |||
Version 3 (production period as of 11/01) | |||
10 | Install in the reverse order |
Parts ordering notes
Part no. | Designation | Quantity |
A 000 420 11 82 | Repair kit (version 1) | 1 |
A 000 420 38 82 | Repair kit (version 2) | 1 |
A 000 420 34 82 | Repair kit (version 3) | 1 |
W 400 589 00 99 00 | SN7 Tool kit | 1 |
W 400 589 02 43 00 | Press in tool for bellows thrust piece | 1 |
W 400 589 03 15 00 | Assembly tool for steel cap | 1 |
Contact partner/order address: Evobus parts warehouse in country in question |