ar9720p1500ff

Cavity preservation following repair work

Type ar · emne 97.20 · version 0106 · 2019-09-25

Gælder for: Model 450.3/4, 451.3/4, 452.3/4, 454.0

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 97 Karrosseritætning, korrosionsbeskyttelse › 97.20 Konservering — Serie 450 (modeller 3**, 4**) · Serie 451 (modeller 3**, 4**) · Serie 452 (modeller 3**, 4**) · Serie 454 (modeller 0**)

EinPAS 40 Konservering/lakering › 40.20 Korrosionsbeskyttelse › 40.20.40 Hulrumskonservering — Serie 450 (modeller 3**, 4**) · Serie 451 (modeller 3**, 4**) · Serie 452 (modeller 3**, 4**) · Serie 454 (modeller 0**)

AR97.20-P-1500FF

Cavity preservation following repair work

24.09.2019

Model

450.3/4, 451.3/4, 452.3/4, 454.0

Danger

Risk of explosion and poisoning caused by solvent vapors and gasses. Risk of injury to skin and eyes when working with anticorrosion agents

Never spray corrosion protection on flames or hot, glowing objects and keep them well away from all potential sources of ignition. Use them only in well-ventilated rooms; wear respiratory protection.

AS97.00-Z-0001-01A

Topical note

Notes on cavity preservation

AH97.20-P-0001-01B

1

Perform repair preservation

Processing instructions for cavity preservation agent

AP97.20-P-0640-01SM

Apply cavity sealant only after sealing and painting work are completed – but before assembly work – from the inside in the repair area .
The processing temperature should not be lower than 15 °C. Carry out cavity preservation twice successively with a flash-off time of 5 min between the processes.

The spraying hose should be stiff and the nozzles should spray at angle to the front and rear. The cavities should be dry.

Insert the spray hose as far as possible into the cavities. Spray while inserting and pulling out slowly.

2

Remove cavity sealant from drain holes

Henviste dokumenter