Remove/install rear seat belts

AR91.40-P-0681EC

Remove/install rear seat belts

10.5.12

 

Remove/install

 Danger!

Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units.

Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply.

AS91.00-Z-0001-01A

 Danger!

Risk of injury caused by release of spring in the automatic belt retractor.

Never disassemble automatic belt retractors.

AS91.00-Z-0002-01A



Notes on performing repair, body work and welding on vehicles with airbags and ETR units

AH91.00-P-0002-01M



Legal requirements on handling and storing airbags and emergency tensioning retractor units

AH91.00-P-0004-01A



Assessment of airbag and belt tensioner units in accident vehicles

AH91.00-P-0006-01B

1

Switch off ignition and remove transmitter key or KEYLESS-GO start/stop button from electronic ignition lock control unit

 KEYLESS-GO start/stop button only with code (889) Keyless-Go.

2

Disconnect ground line for on-board electrical system battery (G1)

Model 204

AR54.10-P-0003CW

Model 207

AR54.10-P-0003EW

3

Remove trim from C-pillar

AR68.30-P-4490EC

4

Unfasten screw (3) on automatic belt retractor (4), until the automatic belt retractor (4) can be removed from the support (5, 6)

 Push luggage compartment lining (2) lightly to one side until the screw (3) is accessible.



*BA91.40-P-1013-01P

5

Remove automatic belt retractor (4) until the electrical connector for the left rear emergency tensioning retractor squib (X28/47) the electrical connector for the right rear emergency tensioning retractor squib (X28/48) is accessible and can then be detached

 Installation: Position and insert automatic belt retractor (4) at supports (5, 6) using screw (3) and guide (7).

6

Detach the electrical connector for the left rear emergency tensioning retractor squib (X28/47) the electrical connector for the right rear emergency tensioning retractor squib (X28/48) from the automatic belt retractors (4)

7

Remove seat belt (1) with automatic belt retractor (4)

 If the automatic belt retractor (4) is replaced, the faulty automatic belt retractor (4) must be disposed of properly. See: 



Notes on disposing of airbag and emergency tensioning retractor units

OS91.00-P-0001-01A

8

Install in the reverse order

9

Check supplemental restraint system (SRS) with STAR DIAGNOSIS

After replacing the automatic belt retractors (4) with seat belt (1).

Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04A

Number

Designation

Model
204.3

Model
207

BA91.40-P-1013-01P

Bolt to rear inertia reel

Nm

35

35