ar8325p1000e

Removing and installing heater housing

Type ar · emne 83.25 · version 0106 · 2004-10-21

Gælder for: MODEL 202

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 83 Klimatisering › 83.25 Varmeautomatik — Serie 202

EinPAS 39 Varmesystem/ventilation/køling › 39.15 Klimatisering › 39.15.32 hus/varmeveksler/fordamper/filter — Serie 202

AR83.25-P-1000E

Removing and installing heater housing

18.6.93

MODEL 202

Removing and installing heater housing

P83.25-0214-06

20 Transverse pipe

23 Hex. head screw

Removing and installing heater housing

P83.25-0222-06

25 Wiring duct

26 Screw

30 Mount

31 Screw

W1 Main ground behind instrument cluster

Removing and installing heater housing

P83.25-0226-06

20 Transverse pipe

22 Hex. nut

23 Hex. head screw

35 Cockpit separation point

40 Ground strap

Removal, installation

Danger!

Risk of injury to skin and eyes from scalding with hot coolant which splashes out. Risk of poisoning from swallowing coolant.

Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage bottles.

Wear protective gloves, protective clothing and eye protection.

AS20.00-Z-0001-01A

1

Drain coolant

Engine 104

ra20001040100x

Engine 111

AR20.00-P-1142HG

Engine 601

ra20006010010x

Engines 604, 605

AR20.00-P-1142HW

Installation: Pour in coolant.

2

Remove cover on left and right air inlets

AR83.25-P-1400E

3

Remove air inlet

AR83.25-P-1401E

4

Remove water collector

up to 31.8.95

AR83.25-P-1402E

as of 1.9.95

AR83.25-P-1402K

5

Remove series resistor for heater blower

6

Pull off heater feed and return hoses, loosen 3 hose clamps

Plug openings (parts kit).

N

Remove instrument panel

Before installing the instrument panel, check for proper functioning.

AR68.10-P-1000E

8

Remove center console

9

Remove floor covering on left and right

10

Remove passenger airbag

Vehicles with passenger airbag (code 291).

AR91.60-P-0680E

11

Remove jacket tube

ra46001247700x

12

Loosen wiring duct (25), unscrew
screws (26)

When installing wiring duct (25) pay attention to screw on mount (arrow) on jacket tube holder.

13

Remove mount (30), unscrew screws (31)

14

Remove transverse pipe (20)

For this purpose, unscrew screws (23) and hex. nuts (22).

15

Disconnect electrical leads from ground point W1

16

Open cable straps (27)

17

Remove rear air ducts on left and right

18

Disconnect vacuum lines at cockpit separation point (35)

19

Remove ground strap (40) on right

20

Separate blower motor connector

21

Remove air ducts to side nozzles on left and right

22

Remove heater housing

23

Install in opposite order

Parts ordering note

Number

Designation

Quantity

Part No.

1

Parts kit

1

140 830 01 27

Henviste dokumenter