ar8285p7472ra

Remove/install operating, display and control unit

Type ar · emne 82.85 · version 0201 · 2008-02-07

Gælder for: MODEL 230.4 as of 15.1.04

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 82 El-system, karrosseri › 82.85 Navigations- og kommunikationssystemer — Serie 230 (modeller 4**)

EinPAS 31 Kommunikation/information/underholdning › 31.10 head unit › 31.10.11 Styreenhed/relæ — Serie 230 (modeller 4**)

AR82.85-P-7472RA

Remove/install operating, display and control unit

24.1.08

MODEL 230.4 as of 15.1.04

Remove/install operating, display and control unit

P82.86-4638-04

Vehicles up to 28.1.08 without code (809) Model year 2009

1 Instrument panel

A40/3 COMAND operating, display and controller unit

Remove/install operating, display and control unit

P82.86-7805-04

Vehicles as of 29.1.08 or with code (809) Model year 2009

1 Instrument panel

2 Screw

A40/3 COMAND operating, display and controller unit

Modification notes

22.11.05

Switch off ignition added

Step 2

Remove/install

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

1

Buffer basic data of COMAND operating, display and controller unit (A40/3) in STAR DIAGNOSIS

When replacing the COMAND operating, display and controller unit (A40/3).

Installation: Transfer buffered basic data to new COMAND operating, display and controller unit (A40/3).

Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04A

2

Switch off the ignition and remove the transmitter key from the EIS control unit

In vehicles with code (889) Keyless-Go, press the Keyless-Go start/stop button repeatedly until the ignition is switched off.

Remove Keyless-Go chip card or transmitter key from vehicle and store beyond the range of the transmitter (at least 2 m).

3

Remove center air vent

On vehicles as of 29.1.08 or with code (809) Model year 2009

AR83.10-P-4503R

4

Remove cup holder

AR68.10-P-1600RA

5.1

Unclip COMAND operating, display and controller unit (A40/3) (arrows) and pull out of instrument panel (1) until electrical connectors on rear of COMAND operating, display and controller unit (A40/3) are accessible

On vehicles up to 28.1.08 without code (809) Model year 2009

5.2

Remove bolts (2) and pull COMAND operating, display and controller unit (A40/3) out of instrument panel (1) until electrical connectors on rear of COMAND operating, display and controller unit (A40/3) are accessible

On vehicles as of 29.1.08 or with code (809) Model year 2009

6

Disconnect connectors on rear of COMAND operating, display and controller unit (A40/3)

To avoid damaging them, do not kink fiber optic cables, route over sharp edges or bend in radii smaller than 25 mm.

7

Cover fiber optic cable coupling and equipment connection on COMAND operating, display and controller unit (A40/3).

AR82.95-P-0005-01A

8

Install in the reverse order

Henviste dokumenter