AR82.61-P-0100AB | Remove/install CD drive in the Audio 50 APS | 15.11.11 |
MODEL 164.### ## as of 006747 with CODE (525) MB Audio 50 APS radio
After expiry of the 24-month manufacturer's warranty for the radio and navigation unit
MODEL 169.### ## as of 044671 up to 2.6.08
except CODE (809) Model year 2009
with CODE (525) MB Audio 50 APS radio
After expiry of the 24-month manufacturer's warranty for the radio and navigation unit
MODEL 203.### ## as of 657109 with CODE (525) MB Audio 50 APS radio
After expiry of the 24-month manufacturer's warranty for the radio and navigation unit
MODEL 209.### ## as of 152581 with CODE (525) MB Audio 50 APS radio
After expiry of the 24-month manufacturer's warranty for the radio and navigation unit
MODEL 245.### ## as of 000331 up to 2.6.08
except CODE (809) Model year 2009
with CODE (525) MB Audio 50 APS radio
After expiry of the 24-month manufacturer's warranty for the radio and navigation unit
MODEL 251.### ## as of 005836 with CODE (525) MB Audio 50 APS radio
After expiry of the 24-month manufacturer's warranty for the radio and navigation unit
P82.61-3656-09
1 CD drive
2 Screw
3 Bolts
4 Screw
8 Bolts
A2/56 Radio and navigation unit
5 Housing upper section
6 Housing lower section
7 Electrical connector
| Remove/install | ||
| Information on preventing damage to electronic components due to electrostatic discharge | ||
| The following error messages require the CD drive (1) to be replaced: - "CD/DVD cannot be ejected" - "General CD/DVD read error" | ||
1 | Remove radio and navigation unit (A2/56) | Model 164 | |
Models 169, 245 | |||
Model 203 as of 24.4.04 | |||
Model 209 as of 1.6.04 | |||
Model 251 | |||
Place radio and navigation unit (A2/56) down on an ESD workplace. The device electronics may be damaged if this is not done. | |||
ESD protection | |||
2 | Remove protective film attached to the side | ||
3 | Remove bolts (2) | ||
4 | Remove screws/bolts (3) | ||
5 | Unscrew screw/bolt (4) | ||
6 | Detach upper section of housing (5) on both sides from lower section of housing (6) using suitable screwdriver | Installation: Ensure that upper section of housing (5) is seated correctly in lower section of housing (6). | |
7 | Swivel upper section of housing (5) upwards until electrical connector (7) is accessible | ||
8 | Carefully detach the electrical connector (7) | Do not touch conductor tracks on circuit board, as otherwise damage may occur to the device's electronics. | |
9 | Remove upper section of housing (5) from lower section of housing (6) | ||
10 | Remove screws/bolts (8) | ||
11 | Spread upper section of housing (5) and remove CD drive (1) from upper section of housing (5) | Installation: Ensure that CD drive (1) is seated correctly in upper section of housing (5). | |
12 | Install in the reverse order | ||
13 | Check navigation function | Start navigation, enter destination and start route guidance. | |
14 | Check playback function of an audio CD |
Henviste dokumenter
- ah5400p000101a Oplysninger med henblik på at undgå skader på elektroniske komponenter på grund af elektrostatisk afladning
- ar8260p7502ak
- ar8260p7502gz
- ar8260p7502rt
- ar8261p7412pa
- ar8261p7412qa