Shown on left front headlamp with bumper removed |
1 | Bolts |
2 | Electrical connector |
S82.10-4513-01
S82.10-4514-01
| Remove/install | ||
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. | |
Topical note | General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system | ||
1.1 | Partly remove left or right bumper, lift carefully and pull slightly out of the side guide until screws (1) are accessible | When removing left headlamp or right headlamp. | |
To do so, remove front grille, if necessary, and remove screws and expansion clips of bumper and fender interior trim on left or right side. | |||
1.2 | Remove front bumper | When removing both headlamps. | |
2 | Remove headlamp | To do this, remove bolts (1) . | |
3 | Release and disconnect electrical connector (2) | ||
4 | Install in the reverse order | ||
| Check | ||
5 | Perform function check of headlamp and headlamp range adjustment | ||
6 | Adjust headlamps | ||
| On vehicles with code LG1 (Bi-xenon headlamp with corner-illuminating fog lamps) | ||
| On vehicles except code LG1 (Bi-xenon headlamps with cornering lights) |
Henviste dokumenter
- ah0000z030001a Generelle oplysninger ved køretøjer med højvoltsnet og/eller litium-ion-batteri og/eller gasdrivsystem samt personligt beskyttelsesudstyr
- ap8210d8260a Kontrol og korrektion af forlygteindstilling
- ap8210d8260b Kontrol, korrektion af forlygteindstilling
- ar8820s2000s
- as0000z003501a Livsfare ved arbejde på komponenter og systemer med U >= 30 V vekselspænding (AC) eller U >= 60 V jævnspænding (DC)