Apply adhesive material for front fixed element of panoramic sliding sunroof

AR77.21-P-0803-04MFA

Apply adhesive material for front fixed element of panoramic sliding sunroof

 Warning

Risk of poisoning caused by inhaling vapors or swallowing adhesive. Risk of injury caused by adhesive coming into contact with skin and eyes

Wear respiratory protection, protective gloves and safety glasses. Pour adhesive into suitable and appropriately marked containers only.

AS00.00-Z-0016-01A



000 588 00 72 00 Sealing and corrosion protection gun

WS97.00-P-0001B

Model

118, 177

with code 413 (Automatic panoramic sliding sunroof)

1

Open adhesive cartridges and insert in sealing and corrosion protection gun.

 To press out the remaining residual quantities in the adhesive cartridges,  insert adapters in adhesive cartridges and plates at push rods of sealing and corrosion protection gun.

2

Actuate sealing and corrosion protection gun until the level in the adhesive cartridges is compensated.

 Both adhesive components should exit from openings in adhesive cartridges.

3

Install mixing tube on adhesive cartridges.

4

Ensure a uniform premixing of the adhesive components; for this purpose, press out and discard two mixing tube lengths.

5

Mix one additional measuring tube length for reference.

 During processing breaks of  15 min, rinse mixing tube by pressing out adhesive material or replace mixing tube taking operation step 4 into account.
The strength of the adhesively bonded connection is otherwise reduced and the required adhesion of the adhesive material is not ensured.

 The reference adhesive bead is used to check and confirm the adhesive curing of the adhesively bonded connection before moving the vehicle for the first time after gluing in the front stationary element (1).

6

Apply adhesive material evenly on the bonding surfaces on the panoramic sliding sunroof frame.

 Apply adhesive material within 25 minutes and position front stationary element (1) and fix in place on the panoramic sliding sunroof frame within no more than a further 15 min.
The strength of the adhesively bonded connection is otherwise impaired and the required adhesion of the adhesive material is not ensured.

 Apply adhesive material in the form of an adhesive bead with a height of approx. 14 mm and a width of approx. 8 to 10 mm. Immediately remove soiling caused by adhesive.