Check gaps and installation depth of door

AR72.10-W-1089C

Check gaps and installation depth of door

28.09.2018

Model

957 with body 957.810

Modification notes

30.08.2018

Work procedure completely revised.

A

Gap dimension

B

Gap dimension

C

Gap dimension

D

Gap dimension

a

Upper edge (for door and cab paneling)

b

Bead (door and cab paneling)

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Notes on safety-relevant components

AH00.00-Z-0019-01A



Check

1

Check installation depth of door.

 The transitions between the door paneling, cab paneling, windshield and door window must be flush without offset.

If the transitions are not flush:



Remove A-pillar trim.

Driver side
Vehicles from vehicle identification number V207053

AR68.30-W-0006A

Passenger side
Vehicles from vehicle identification number V207053

AR68.30-W-0007A

 There are no repair instructions for the removal/installation of the A-pillar trim for vehicles up to vehicle identification number V 207052.

Adjust installation depth of door.

AR72.10-W-1090-02E

 Bolt, hinge to A-pillar

*BA72.10-N-1007-01B

 Screw/bolt, lock wedge to cab

*BA72.10-N-1044-01B

 Lifting device

*000588048000

Check installation depth of door again and repeat adjustment if necessary.

Install A-pillar paneling.

Driver side
Vehicles from vehicle identification number V207053

AR68.30-W-0006A

Passenger side
Vehicles from vehicle identification number V207053

AR68.30-W-0007A

2

Check gap dimensions (A, B, C, D) of door.

 The gap dimensions (A, D) and the gap dimensions (B, C) must each be identical and the door must be in the center.
The upper gap dimension results when the ridge (b) is flush with the upper edge (a).

 Feeler gauge

*129589032100

If the gap dimensions (A, B, C, D) are incorrect:



Adjust gap dimensions (A, B, C, D) of door.

AR72.10-W-1090-01NE

 Bolt, hinge to front door

*BA72.10-N-1008-01B

 Screw/bolt, lock wedge to cab

*BA72.10-N-1044-01B

 Lifting device

*000588048000

 Feeler gauge

*129589032100

Check gap dimensions (A, B, C, D) again and repeat adjustment if necessary.

 Front door

Number

Designation

Model 957

BA72.10-N-1007-01B

Bolt, hinge to A-pillar

Nm

30

 Front door

Number

Designation

Model 957

BA72.10-N-1008-01B

Bolt, hinge to front door

Nm

30

 Front door

Number

Designation

Model 957

BA72.10-N-1044-01B

Screw/bolt, lock wedge to cab

Nm

25