P68.30-3654-09
Shown on left side of vehicle |
1 | Cover | 5 | Edge guard | |
2 | Cover | 6 | Expansion clips | |
3 | Screw | 7 | Trunk illumination electrical connector | |
4 | Anchoring lug | 8 | Edge guard |
| Remove/install | ||
1 | Remove trim from C-pillar | ||
2 | Remove trim from rear end center assembly | ||
3 | Remove rear backrest | ||
4 | Detach edge guard (5) in area of paneling (1) | Installation: Ensure that the edge guard (5) is properly seated. | |
5 | Unclip cover (2) from anchoring lug (4) | ||
6 | Unscrew bolt (3) and remove anchoring lug (4) | ||
7 | Remove expansion clips (6) | ||
8 | Disconnect electrical connector from trunk illumination (7) | Only when removing left paneling (1). | |
9 | Unclip and remove molding (1) | Installation: Ensure that the edge guard (8) is properly seated. | |
10 | Install in the reverse order |