ar6830p4495lw

Removing and installing trim panel at D-pillar

Type ar · emne 68.30 · version 0101 · 2015-02-13

Gælder for: MODEL 205.2

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 3 Karrosseri › 68 Indvendig udrustning › 68.30 Beklædninger, pynterammer — Serie 205 (modeller 2**)

EinPAS 37 Indvendigt udstyr › 37.45 Beklædning › 37.45.30 Beklædning kabine — Serie 205 (modeller 2**)

AR68.30-P-4495LW

Removing and installing trim panel at D-pillar

2.2.15

MODEL

205.2

Removing and installing trim panel at D-pillar

Shown on right side of vehicle, with CODE 810 (Sound system) and CODE 890 (EASY-PACK liftgate)

1

D-pillar paneling

2

Cargo area side paneling

3

Edge guard

4

Electrical connector (with CODE 890 (EASY-PACK liftgate))

5

Bolts

6

Roller blind guide

7

Electrical connector

8

Mounting clamp

P68.30-3824-06

Danger !

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Notes on sensor system for trunk lid opening/closing

AH80.61-P-0001-01A

Remove/install

1

Detach left and right cargo area side paneling (2) in rear area until bolts (5) are accessible

AR68.30-P-1180LWS

2

Detach edge guard (3) in area of D-pillar paneling (1)

3

Disconnect electrical connection (4)

MODEL 205.2
with CODE 890 (EASY-PACK-tailgate)

4

Remove screws (5)

5

Move roller blind guide (6) out of D-pillar paneling (1) in direction of arrow and remove

6

Unclip D-pillar paneling (1) in rear area as shown

7

Disconnect electrical connector (7)

8

Carefully unclip D-pillar paneling (1) and remove

Installation: Ensure that mounting clips (8) are seated correctly.

9

Install in the reverse order

Henviste dokumenter