Remove/install load compartment inner side paneling

AR68.30-P-1180LWS

Remove/install load compartment inner side paneling

06.12.2019

Model

205.2

Shown on model 205.2 (except 205.213/247/253)

1

Luggage compartment roller blind

7

Electrical connector

12

Right side load compartment paneling

2

Load compartment floor front section

8

Screw

13

Left top side load compartment paneling

3

Rear center section paneling

9

Cover

14

Right top side load compartment paneling

4

Carpet strip

10

Edge guard

15

Cover

5

Carpet strip

11

Left side load compartment paneling

16

Tie-down eye

6

Electrical connector

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

 Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

Topical note

General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system

AH00.00-Z-0300-01A

Notes on HANDS-FREE ACCESS

AH80.61-P-0001-01A

 

Remove/install

1

Release and fold over left and right seat backrest in the rear passenger compartment.

2

Remove left and right side bolster in the rear passenger compartment.

AR91.12-P-1710LW

3

Open tailgate.

4

Release and remove luggage compartment roller blind (1).

5.1

Remove load compartment floor front section (2).

Model 205.2 (except 205.213/247/253)

AR68.80-P-0010LWS

5.2

Remove high-voltage battery cover.

Model 205.213/247/253

AR68.80-P-6000LWH

6

Remove rear-end center section trim (3).

AR68.30-P-4785LWS

7.1

Remove left carpet strip (4) and right carpet strip (5).

Model 205.2 (except 205.213/247/253)

7.2

Remove tie-down eyes (16).

Model 205.213/247/253

 Screw/bolt for tie-down eye

*BA68.50-P-1001-03I

8.1

Remove screw (8) and unclip cover (15).

When removing right side load compartment trim (12).

8.2

Unclip cover (9).

When removing left side load compartment trim (11).

 Installation: Ensure that spring below upper section of cover (9) is seated correctly.

 Cover (9) consists of two parts.

9

Unclip left side load compartment trim (11) and right side load compartment trim (12) from the rear toward the front.

 Installation: Ensure that edge guard (10) is seated correctly.

10

Disconnect left and right electrical connector (6).

11

Detach electrical connector (7).

When removing left side load compartment trim (11).

12

Remove left side load compartment trim (11) and right side load compartment trim (12).

13

Unclip left top side load compartment trim (13) and right top side load compartment trim (14) and remove.

14

Install in the reverse order

 Cargo retainers

Number

Designation

Model 205

BA68.50-P-1001-03I

Screw/bolt for tie-down eye

Nm

24