P68.30-3807-08
1 | D-pillar paneling | 7 | Cargo area paneling | |
2 | Rear center section paneling | 8 | Socket | |
3 | Load compartment floor | 9 | Cover | |
4 | Expansion rivet | 10 | Cover | |
5 | Tie-down eye | 11 | Net stowage compartment | |
6 | Screw |
P68.30-3808-08
1 | D-pillar paneling | 14 | Cover | |
7 | Side paneling | 15 | Seat backrest | |
12 | Door sill | 16 | Bow | |
13 | Edge guard |
P68.30-3809-08
7 | Cargo area paneling | 17 | Electrical connector | |
8 | Socket |
| Remove/install | ||
1 | Detach left and right D-pillar paneling (1) and lay seat belt down to side | ||
2 | Remove rear center section paneling (2) | ||
For this purpose remove load compartment floor (3). | |||
3 | Remove expansion rivets (4) | Installation: Replace damaged expansion rivets (4). | |
4 | Remove left and right tie-down eye (5) | For this purpose remove cover on tie-down eye (5) and unscrew bolt (6). | |
5 | Remove left and right door sill (12) | Clip remover | |
6 | Detach edge guard (13) in area of cargo area paneling (7) | Installation: Ensure that the edge guard (13) is properly seated. | |
Clip remover | |||
7 | Remove cover (14) from belt end fitting | ||
8 | Remove left and right backrest (15) | ||
9 | Detach cargo area paneling (7) on left and right in cargo area and remove until electrical connector (17) on socket (8) is accessible | When removing left cargo area paneling (7). | |
10 | Disconnect electrical connector (17) from socket (8) | With CODE U35 (12 V socket in cargo area) | |
11 | Push cargo area paneling (7) on left and right into cargo area toward front over bracket (16) and remove | Move bracket (16) to upper position (arrow). | |
Installation: Bracket (16) should be in upper position (arrow). | |||
12 | Transfer socket (8) in cargo area | When replacing left cargo area paneling (7). | |
13 | Transfer covers (9, 10) and net stowage compartment (11) | When replacing cargo area paneling (7). | |
14 | Install in the reverse order |
452 589 01 63 00
Clip remover