Removing and installing trim panel at D-pillar

AR68.30-P-4495NKC

Removing and installing trim panel at D-pillar

27.11.2014

MODEL

117.9

1

Cover

2

Nut

3

Seat backrest

4

Cover

5

Edge guard

6

Cover

9

Seat belt

6

Cover

8

Electrical connector

7

Electrical connector

 Danger !

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

 

Remove/install

1

Adjust left and right front seat toward front

2

Remove cover (1) and unscrew nut (2) from belt end fitting

 Nut, rear belt buckle/belt end fitting to body/pivot bearing

*BA91.40-P-1009-01S

3

Fold over left and right backrest (3)

4

Unclip cover (4) and press associated clips together and remove from body

 Clip remover

*452589016300

5

Loose edge guard (5) in area of paneling (6)

 Installation: Ensure that the edge guard (5) is properly seated.

6

Unclip paneling (6) and remove

 Remove paneling (6) until electrical connectors (7, 8).

 Clip remover

*452589016300

7

Disconnect electrical connector (7)

With CODE 810 (Sound system)

8

Disconnect electrical connector (8)

9

Remove cover (6)

 Guide seat belt (9) through paneling (6).

10

Install in the reverse order

 Seat belts/emergency tensioning retractors

Number

Designation

MODEL 117

BA91.40-P-1009-01S

Nut, rear belt buckle/belt end fitting to body/pivot bearing

Nm

35