Remove/install center console

AR68.20-P-2000AM

Remove/install center console

16.2.12

 

Remove/install

1

Remove selector lever cover (8)

Position selector lever in position "D"

AR68.20-P-2310M

2

Connect quiescent current retention device

AR54.10-P-1030-07I

Danger!

Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices

No fire, sparks, open flames or smoking.

Wear acid-resistant gloves and clothing and safety glasses with side guards.

Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground.

Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers.

AS54.10-Z-0001-01A

3

Disconnect ground cable of battery

 Turn key in electronic ignition switch EIS into position "0". Key cannot be withdrawn.

AR54.10-P-0003I

 Vehicle fitted with code (889) Keyless-Go:

Switch off engine, remove Keyless Go cards from the vehicle and keep outside the range of the transmitter.

 Ensure that ground cable will not come into renewed contact with the battery terminal as you are working.

 Installation: Read out fault memory after connecting, adjust time display on combination instrument, code radio, normalize power window and activate steering angle sensor.

Vehicles with stationary heater: adjust time display on stationary heater.



Notes on battery

AH54.10-P-0001-01A

4

Open stowage compartment lid (10) in front of selector lever, unclip floor (9) and take out

5

Unscrew screws (1)

6

Unscrew screw (2)

 Move driver and front passenger seat to foremost position.

7

Unclip and remove top cover (5)

8

Disconnect connector of rear compartment nozzle adjustment illumination

9

Disconnect connector of stowage compartment illumination

10.1

Disconnect connector of telephone system

 Only with code 316 MB telephone, D-network (D2B) in armrest.

 Only with code 317 Portable CTEL telephone, D-network (D2B) in armrest.

11

Disconnect TV connector in rear

12

Lift rear center console (3) and guide out of instrument panel

 Keep lid (10) closed.

13

Install in the reverse order

14

Render electrical system operational

 Perform basic programming (normalize windows and sliding roof, etc.).

AR00.19-P-0200M

15

Carry out function test