The superordinate service document as well as the safety information in the service document must be observed.
The next steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.
The following commercially available tools are required to perform operation steps: rotary wire brush, multifunction unit (spot welding), wet/dry vacuum cleaner.
W65.10-1048-09
1 | Drill holes for MAG welding (areas F, G, H). |
2 | Grind mating surfaces down to bare metal (areas A, B, C, D, E, F, G, H, I, J). |
Sand down to bare metal spot weld flanges in the crosshatched areas on both sides. |
3 | Grind spot weld flanges of the bracket (K) on both sides down to bare metal. |
4 | Transfer the dimension (x) of the undamaged side of vehicle to the new part. |
5 | Apply zinc dust paint to insides of spot weld flanges. apply zinc dust paint. |
6 | Install the bracket (K) in accordance with the calculated dimension, fit and attach them. |
7 | Bracket (K) . |
8 | Remove shavings and drill chips. |