The following steps are shown on the left side of the vehicle and must be performed analogously on the right side in the event of damage.
1 | Grind mating surfaces on rear fender (1) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
2 | Remove grinding dust and drill chips. |
3 | Coat insides of spot weld flanges with zinc dust paint. |
Do not coat bonding surfaces with zinc dust paint (area A). |
Observe pretreatment of bonding surfaces. |
P63.50-4137-05
4 | Grind mating surfaces on rear fender (1) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
5 | Remove grinding dust. |
6 | Coat insides of spot weld flanges with zinc dust paint. |
P63.50-4138-06
7 | Grind mating surfaces on rear fender (1) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
8 | Remove grinding dust. |
9 | Coat insides of spot weld flanges with zinc dust paint. |
P63.50-4139-06