Test and adjustment values, gap dimensions at hoods, doors and covers
Number | Designation | Model | Model | |||
BE60.00-P-1001-01A | Gap dimension | Engine hood to fender | Dimension "A" | mm | 5.0 (1) | 3.0 (+0.8) |
Engine hood to headlamp | Dimension "R" | mm | 5.0 (1) | 3.0 (1.2) | ||
Engine hood to radiator grille | Dimension "O" | mm | 3.0 (1) | 6.0 (0.5) | ||
Radiator grille to headlamp | Dimension "N" | mm | - | - | ||
See picture | ||||||
BE60.00-P-1002-01A | Gap dimension | Front door to A-pillar | Dimension "B" | mm | - | - |
Front door to fender | Dimension "H" | mm | 3.5 (1) | 3.0 (0.8) | ||
Front door to rear door | Dimension "I" | mm | - | - | ||
Front door to roof | Dimension "C" | mm | - | - | ||
Rear door to top of side section | Dimension "D" | mm | - | - | ||
Rear door to side section, bottom | Dimension "J" | mm | - | - | ||
Fender to A-pillar | Dimension "Q" | mm | 4.5 (0.5) | 2.0 (+1.5/-0.5) | ||
Front door to rear fender | Dimension "P" | mm | 3.5 (1) | 3.0 (+0.8) | ||
See picture | ||||||
BE60.00-P-1003-01A | Gap dimension | Trunk lid to rear fender, top | Dimension "F" | mm | 4.0 (1) | - |
Trunk lid to bottom of rear fender | Dimension "M" | mm | - | - | ||
Trunk lid to rear fender | Dimension "F" | mm | 4.0 (1) | 3.0 (+1.2) | ||
Trunk lid to rear lamp unit | Dimension "M" | mm | 3.0 (1) | 4.0 (+1.6/-0.8) | ||
Trunk lid to bumper | Dimension "V" | mm | 5.0 (1) | 5.0 (+1.5/-1.0) | ||
Rear fender to rear lamp unit | Dimension "U" | mm | 1.5 (1) | 2.50.5 | ||
See picture | ||||||
BE60.00-P-1005-01A | Gap dimension | Fuel filler flap | Dimension "K" | mm | - | 3.0 (+0.8) |
Dimension "L" | mm | - | - | |||
See picture | ||||||
129 589 03 21 00
Feeler gauge
P00.01-2125-06
Shown on model 230 without code (P99) Special model "AMG Black Series"
Adjust hoods, doors and covers according to drawings. The gap should not run wedge-shaped or be too narrow at points. Deviations from parallel gap should be max. 0.5 mm over the entire length. If the inside clearance is too large or too small, the movable body parts must be centered accordingly. The reference measurements apply only for repair work on bodies damaged in accidents.
P00.01-2126-06
Shown on model 230 without code (P99) Special model "AMG Black Series"