1 | Extraction hook |
2 | Digital tachograph DTCO |
3 | Tachograph housing |
B54.61-1107-06
4 | Instrument cluster |
B54.30-1310-01
5 | Connector D (brown) |
6 | Conjugated connectors A and B (black) |
B54.61-1106-10
| Remove/install | ||
1 | Attach the conjugated connectors (6) and the connector (5) to its respective sockets | The PTC element of the tachograph power harness should be replaced from 1,5A to 2,70A. In case of no-replacement, the printing process will be interrupted. | |
2 | Provisionally position the DTCO digital tachograph (2) in its housing (3) without locking it in its end position | ||
3 | Reset the installation of the positive battery terminal power supply and connect the general key | ||
4 | Perform the browsing on the instrument cluster (4) until access the TCO | The new recognized number should be A9584460433. | |
The date and time will be adjusted automatically by adopting the information stored in the INS memory, however the distance values (km) should be adjusted during the calibration. | |||
5 | Connect the diagnostic device and read the fault memory | ||
6 | Remove the DTCO digital tachograph (2) from its housing (3) | If necessary, the extraction hooks should be used (1) to remove it. | |
7 | Mount the connectors rear cover supplied together with the tachograph and seal | Use the seal A0005421790 to seal it | |
8 | Introduce the DTCO digital tachograph (2) definitely in the housing (3) until its locking position. |