Remove/install purge control valve

Type ar · emne 47.30 · version 0101 · 2004-04-15

Gælder for: ENGINE 111.984 in MODELS 901.6, 902.6, 903.6, 904.6

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 47 Brændstofsystem, energiforsyning drivline › 47.30 Brændstoffordampningssystem — Serie 901 (modeller 6**) · Serie 902 (modeller 6**) · Serie 903 (modeller 6**) · Serie 904 (modeller 6**)

EinPAS 16 Brændstof-/energiforsyning motor › 16.10 Brændstofforsyning › 16.10.13 ledning/slange/ventil — Serie 901 (modeller 6**) · Serie 902 (modeller 6**) · Serie 903 (modeller 6**) · Serie 904 (modeller 6**)

Gælder også for motorer/gearkasser: 111 984

AR47.30-D-8220A

Remove/install purge control valve

23.8.99

ENGINE 111.984 in MODELS 901.6, 902.6, 903.6, 904.6

D47.30-1102-12

1 Connector

2 Purge control valve

3 Line of switchover valve/idle speed control actuator

4 Line of switchover valve/activated charcoal canister

 	Remove/Install
1	Remove air intake hose		AR09.10-D-8030F
2	Remove the connector (1) at the purge control valve (2)
3	Detach lines (3 and 4) from purge control valve
4	Take off the purge control valve (2) from the bracket in the upward direction	 Installation: While connecting the switchover valve, pay attention to the marking "MOT" on the housing. The arrow must point to the idle speed control actuator.
5	Install in the reverse order