G46.10-3152-11
1 Steering wheel
2 Impact absorber
3 Electrical connector
4 Screw
Modification notes
| Remove/install | ||
1 | Remove impact absorber (2) | The impact absorber (2) is plugged in. | |
2 | Separate electrical connectors (3) | ||
3 | Remove bolt (4) | | |
4 | Manually detach steering wheel (1) | If the plant marking on steering wheel (1) and steering shaft is not present, the position of steering wheel (1) relative to the steering shaft must be marked before pulling off the steering wheel (1). | |
Installation: Observe marking of installation position of steering wheel (1) relative to steering shaft. | |||
5 | Install in the reverse order | ||
6 | Conduct a road test | During the test drive, check the turn signal cancellation function and the position of the steering wheel (1). If the steering wheel (1) is not on straight offset this by a maximum of 1 tooth, if deviation is larger: | |
Check and adjust center steering position on steering gear |
Steering wheel, jacket tube, steering shaft