AR42.10-W-0320B | Removing and installing service brake valve | 16.6.97 |
Model 375.1, 958.0, 970, 972, 974, 975, 976
W42.10-0122-09
1 Coolant compensation tank
2 Connector
3 Service brake valve
4 Compressed-air line
5 Compressed-air line
6 Compressed-air line
13 Front flap
14 Front trim panel
15 Interior trim panel
16 Clutch switch connector
17 Stop lamp switch connector
7 Compressed-air line
8 Vent line
9 Connector
10 Pedal unit
11 Bolt
12 Bracket
| Remove/Install | ||
| Notes on self-locking nuts and bolts | ||
1 | Switch off ignition | ||
2 | Remove inner paneling (15) | ||
3 | Disconnect clutch switch connector (16) and stop lamp switch connector (17) | ||
4 | Discharge compressed-air system | ||
5 | Open front flap (13) | ||
6 | Remove front paneling (14) | ||
7 | Disconnect connector (2) and detach coolant expansion tank (1) | ||
8 | Disconnect vent line (8) | ||
9 | Label compressed air lines (4, 5, 6 and 7) according to labeling on service brake valve (3) and remove | Installation: Install new O-rings and note marking. | |
With compressed air connection system "VOSS 230". | |||
With compressed air connection system "VOSS 232" (NG 8, 12) or "SCHÄFER SDF" (NG 6). | |||
| Notes on compressed air connection systems | ||
10 | Remove bracket (12) of compressed air lines (4, 5, 6 and 7) | ||
11 | Remove pedal unit (10) | ||
12 | Remove service brake valve (3) | Installation: Replace bolts (11). | |
| |||
13 | Install in the reverse order | ||
14 | Fill compressed-air system | Run the engine until the service pressure is reached. |
Service brake valve/brake value sensor
Henviste dokumenter
- ah0000n000101a Oplysninger om selvlåsende bolte og møtrikker
- ah0018n000101a Oplysninger om trykluftstikforbindelsessystemer
- ar4210w0900a Af-, påmontering af stikforbindelse trykluftrør
- ar4210w0900c Afmontering, montering af stikkobling trykluft