W42.10-1136-06
1 Brake caliper
4 Protective metal cap
4.1 Sealing ring
5 Sensor line plug
| Remove/install | ||
1 | Remove wheel | ||
2 | Remove brake pads | ||
3 | Unplug electrical connector of brake wear sensor | Detach and connect the sensor line connector (5) axially only, and loosen and tighten the threaded connection carefully, as a new brake caliper (1) must be installed if the plug-in connection or the threaded connection is damaged. | |
| |||
4 | Remove brake cylinder | ||
5 | Remove the protective metal cap (4) | ||
Installation and removal tool for steel cap on outer fixed bearing (disk brake SB7000) | |||
6 | Remove brake caliper (1) from brake carrier. | Installation: Use new bolts. | |
| |||
7 | Check brake caliper (1) for condensed water and corrosion. | Condensed water in the housing of the brake caliper (1) or traces of corrosion on the sealing surface, housing opening, and brake lever indicate a defective combination cylinder. In this case, a new combination cylinder and a new brake caliper (1) must be installed. | |
8 | Install in the reverse order |
Rear axle brake caliper
Number | Designation | Models 613.358/388 with rear axle 746.217 | ||
BA42.10-N-1001-12I | Bolt, brake caliper to brake carrier | Stage 1 | Nm | 180 |
Stage 2 | ° | 90 | ||
BA42.10-N-1002-12I | Bolt connecting brake wear sensor to brake caliper | Nm | 1 | |
Auxiliary repair materials
Number | Designation | Order number |
BR00.45-Z-1021-06A | Assembly grease (white) | Knorr-Bremse AG |