16 | Threaded pipes |
22 | Internal protection bellows |
L | Tool composed of K3 + K4 + K9 |
X | Sealing surface of protection bellows on calipers SN7000 |
Y | Sealing surface of protection bellows on calipers SB7000 |
B42.10-0360-03
| Remove | ||
1 | Remove the brake caliper | Remove/install brake caliper | |
Remove/install brake caliperKnorr brake caliper series SB7000 | |||
With brake caliper without pads, clean and on a suitable bench, fully return threaded pipes (16) by turning the clearance adjuster counterclockwise. | |||
2 | Remove the bushings from threaded pipe (16) ends | ||
3 | Clean the entire internal protectors' area (22) | The sealing surfaces (X) for SN7000 and (Y) for SB7000, both from the internal protection bellows, as well as the threaded pipes, should not be damaged when removing the protectors. These parts cannot be replaced. | |
4 | Remove the internal protection bellows (22) carefully | For that, use a screwdriver with no sharp corners. | |
5 | Clean the sealing surfaces (X, Y) | ||
| Install | ||
6 | Mount the internal protection bellows (22) to the threaded pipes (16) of the pressure pieces | ||
7 | Remove bushing from pressure piece | The bushings do not need lubrication. | |
8 | Place the tool composed of K3 + K4 + K9 (L). This should be guided over the threaded pipe (16) pin | Removal and installation tool | |
Threaded insert | |||
9 | Fully press the internal protection bellows (22) into the respective container by turning the hexagonal part of the tool composed of K3 + K4 + K9 with a fixed wrench | ||
10 | To check for the correct mounting of the inner protectors (22), turn the slack adjuster clockwise to move the threaded pipe (16) forward | In this operation, the internal protector (22) should not rotate. |
055 589 01 63 00
Threaded insert
055 589 01 61 00
Removal and installation tool