ar4110p005017msc

Tightening procedure for rear propeller shaft to transfer case

Type ar · emne 41.10 · version 0100 · 2019-03-08

Gælder for: Model 167

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 41 Kardanaksel › 41.10 Kardanaksel — Serie 167

EinPAS 17 Drivstreng/aksel › 17.40 Kardanaksel › 17.40.30 Kardanaksel drivmekanisme/firehjulstræk — Serie 167

AR41.10-P-0050-17MSC

Tightening procedure for rear propeller shaft to transfer case

Topical note

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

Topical note

Notes on threaded connections fastened using a tightening angle-based tightening process

AH00.00-P-0020-01A

Model

167

Propeller shaft

Number

Designation

Model 167

BA41.10-P-1001-01F

Self-locking screw/bolt of propeller shaft at transfer case/adapter housing (to rear axle)

Stage 1

Nm

40

Stage 2

°

90

Tightening procedure for rear propeller shaft to transfer case

164 589 02 07 00

Retainer wrench

Tightening procedure for rear propeller shaft to transfer case

Remove

1

Mark position of rear propeller shaft relative to flange of transfer case in order to reproduce the factory installation position during installation.



2

Remove screws (1 to 6) at transfer case and detach rear propeller shaft from transfer case.


Counterhold flange on transfer case with retainer wrench.


P41.00-A000-11

Install

It is essential to observe the tightening procedure for the screws (1 to 6) securing the rear propeller shaft to the transfer case.
Otherwise, there are vibrations and noise development at high speeds.

The screws (1 to 6) securing the rear propeller shaft to the transfer case must always be replaced.

3

Align markings with each other.

4

Tighten screws (3, 6) to initial torque of 10 Nm and mark.

5

Tighten screws (1 to 6) in numerical sequence   .