AR40.30-P-0451D | Checking alignment of steering knuckle (removed) | 26.9.96 |
MODEL 210.081 /082 /083 /281 /282 /283
P40.30-0336-01
Left steering knuckle shown
P40.30-0337-01
P40.30-0339-01
P40.30-0338-01
| Removal, installation | ||
1 | Remove and install steering knuckle | ||
| Measuring | ||
2 | Place steering knuckle with wheel hub or brake disc installed on parallel supports | | |
3 | Scan and note height dimension "A" as comparative dimension with a height marking device | Measure at the flat surface of the brake caliper mounting. | |
4 | Scan and note height dimension "B1-B3" at the lowest point of the each bore. | The test values result from the difference in height dimension "A" to the height dimensions: "B1"= Bearing of supporting joint "B2"= Bearing of upper wishbone "B3"= Bearing of steering knuckle arm/tie rod |
Test values - steering knuckle
Number | Designation | Models 210.08/28 | ||
BE40.30-P-1001-01A | Difference in height measurement | "A" – "B1" | mm | 23.31 |
"B2" – "A" | mm | 65.61 | ||
"B3" – "A" | mm | 1.81 | ||
Refer to illustration | ||||
Commercially available tools