Check vehicle level at front and rear axle with electronic inclinometer, adjust if necessary

AR40.20-P-0301D

Check vehicle level at front and rear axle with electronic inclinometer, adjust if necessary

10.11.11

22.2.00

Value changed from 8.2 to 7.2 °

Value in BE40.20-P-1002-02D changed for model 210.6

*BE40.20-P-1002-02D

22.2.00

Value changed from 2.0 to 1.3 °

Value in BE40.20-P-1002-03D changed for model 210.6

*BE40.20-P-1002-03D

Checking



On vehicles with level control a vehicle level too low shouldnotbe corrected by changing the level control connection rod (control point).

a) Check function of level control.

b) If OK, adjust the vehicle level by changing the spring or spring rubber mount.

1

Observe general information on wheel alignment.

 Following repair work forcefully move vehicle up and down several times before measuring.

AR40.20-P-0201A

2

Install measuring plate (086b) in the recess in the lower wishbone.

 The groove in the measuring plate (086b) should be at an angle of 90° to the direction of travel.

 Clean measuring point at bottom wishbone.

 Remove metal chips from measuring plate.

 Measuring plate is magnetic, information on data carriers, e.g. floppy discs, credit cards, etc. can be rendered unusable.

Car chassis measuring device - electronic - with cable

gotis://F_40.2_01.0

3

Check vehicle level at the front axle via the wishbone inclination.

Attach measurement sensor (086a) (connecting cable pointing to center of vehicle) and store each measured value.

 Left front measuring point 1

 Right front measuring point 2

Car chassis measuring device - electronic - with cable

gotis://F_40.2_01.0

*BE40.20-P-1002-02D

4

Check vehicle level at the rear axle via the rear axle shaft inclination.

Attach measurement sensor (086a) to left and right rear axle shaft (connecting cable pointing to center of vehicle) and store each measured value.

 Clean measuring points on rear axle shaft

 Left rear measuring point 3

 Right rear measuring point 4

Car chassis measuring device - electronic - with cable

gotis://F_40.2_01.0

*BE40.20-P-1002-03D



Vehicle level outside of tolerance on front and rear axle.

Adjust vehicle level by changing the springs or spring rubber mounts.

AR40.20-P-0300-01B

Number

Designation

Model 210.08/28

Model 210.6

BE40.20-P-1002-02D

Vehicle level - front axle

°

+1.2 (-2.1/+1.4)

+7.2 (-2.2/+1.6)

Number

Designation

Model
210.20/21/22/
23/26/27
Classic/
Elegance,
model
210.08/28
with level
control

Model
210.08
without level
control

Model
210.6
with level
control

BE40.20-P-1002-03D

Vehicle level - rear axle

°

+1.9 (1.0)

+2.3 (1.0)

+1.3 (1.0)