W35.50-1039-06
1 Bolt
2 Cover
3 Gasket
4 Locking bolt
5 Flange
6 Outer tapered roller bearing
7 Outside outer race
8 Rocker arm
9 Inside outer race
10 Radial seal
11 Inner tapered roller bearing
12 Thrust ring
13 Swing axle
14 Spring shackle
| Removing | ||
1 | Remove wheel hub with axle supporting tube | ||
2 | Support vehicle at frame | ||
3 | Remove cover (2) | ||
4 | Unscrew locking bolt (4) from flange (5) | ||
5 | Remove rocker arm (8) from swing axle (13) | ||
| |||
| |||
| |||
6 | Remove outer tapered roller bearing (6) from rocker arm (8) | ||
7 | Remove radial seal (10) | ||
8 | Replace rocker arm bearing | ||
| |||
| |||
Hot-air gun | |||
| Installing | ||
9 | Install radial seal (10) | Coat circumference of radial seal without rubberized external surface with sealant.. | |
| |||
10 | Push rocker arm (8) onto swing axle (13) | ||
11 | Insert tapered roller bearing (6) into rocker arm (8) | Heat tapered roller bearing to approx. 80 °C. | |
12 | Tighten flange (5) | Continuously turn rocker arm (8) so that tapered roller bearings fit in place and run free of clearance. | |
| |||
| |||
13 | Screw locking bolt (4) into flange (5) | | |
14 | Install cover (2) | | |
15 | Fit rocker arm (8) at spring shackle (14) | | |
16 | Install wheel hub with axle supporting tube |
Trailing axle
Number | Designation | Trailing axle | |||
BA35.50-N-1001-03A | Bolt, rocker arm to spring shackle | Nm | 750 | ||
BA35.50-N-1003-03A | Flange to swing axle | Nm | 1915 | ||
BA35.50-N-1004-03A | Flange locking bolt | Nm | 150 | ||
BA35.50-N-1005-03A | Bolt, cover to rocker arm | Nm | 10 | ||
740 589 01 15 00
Puller
Drift
Claw-type wrench
Pulling device
648 589 01 07 00
000 589 45 33 00
648 589 01 33 00
648 589 01 63 00
Thrust piece
Ratio wrench
000 589 69 63 00
Repair materials
Number | Designation | Order number |
BR00.45-Z-1092-02A | Adhesive kit, body, 2-component adhesive | A 009 989 36 71 |