ar3550t0035a

Remove/install trailing axle compressed air cylinder

Type ar · emne 35.50 · version 0102 · 2006-07-12

Gælder for: Rear axle 749.731 in MODEL 375.323 with CODE (AN5) Trailing axle, lifting Rear axle 749.732 in MODEL 375.321 with CODE (AN5) Trailing axle, lifting Rear axle 749.733 in MODEL 375.322 /381 with CODE (AN5) Trailing axle, lifting

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 35 Bagaksel › 35.50 Ekstra aksler (forløbs-/efterløbs-/midter-/anhængeraksel) — Serie 375 (modeller 321, 322, 323, 381)

EinPAS 17 Drivstreng/aksel › 17.52 Ekstra aksel › 17.52.33 Cylinder — Serie 375 (modeller 321, 322, 323, 381)

Gælder også for motorer/gearkasser: 749 731, 749 732, 749 733

AR35.50-T-0035A

Remove/install trailing axle compressed air cylinder

17.6.02

Rear axle 749.731 in MODEL 375.323 with CODE (AN5) Trailing axle, lifting

Rear axle 749.732 in MODEL 375.321 with CODE (AN5) Trailing axle, lifting

Rear axle 749.733 in MODEL 375.322 /381 with CODE (AN5) Trailing axle, lifting

Remove/install trailing axle compressed air cylinder

T35.50-0027-06

1 Compressed air cylinder

2 Compressed-air line

3 Compressed-air line

4 Lubricating nipple

5 Locking plate

6 Pin

8 Washer

9 Cotter pin

10 Pin

Remove/Install

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

1

Trailing axle lowered

2

Discharge compressed-air system

3

Detach compressed-air lines (2, 3) from compressed air cylinder (1).

With compressed air connector system "VOSS 230".

AR42.10-W-0900A

With compressed air connector system "VOSS 232" (NG 8, 12) or "SCHÄFER SDF" (NG 6).

AR42.10-W-0900C

Installation: Check O-rings and replace if necessary.

Notes on compressed air connector systems

AH00.18-N-0001-01A

4

Unscrew lubricating nipple (4).

5

Remove locking plate (5).

6

Remove pin (6) from the inside outwards

Secure compressed air cylinder (1) to prevent it from falling down.

Installation: Press in pin (6) from the outside inwards. The locking slot must run parallel to both tapped holes for the locking plate (5).

7

Lower the compressed air cylinder (1) until the connecting rod eye is free.

Installation: Align the connecting rod eye accurately so that the pin (6) can then be installed .

8

Remove cotter pin (9) and washer (8).

9

Press out pin (10) from the inside outwards and remove with compressed air cylinder (1).

When putting down the compressed air cylinder (1) do not damage the screw-on filter on the underneath.

Installation: The screw-on filter must point downwards.

Lubrication points

Lubricate pin (10).

AP00.20-W-0020A

10

Install in the reverse order

Henviste dokumenter