1 | Wheel stop screw |
2 | Counter nut |
B33.25-0010-01
| Check | ||
1 | Place the vehicle with front axle wheels to be verified at the center of the turntable | The wheels of the front axle to be checked must be straight forward. | |
2 | Put the spinning plate's scale at the 0° angle | ||
3 | Turn the steering wheel to the left until the stopper and keep it in this position | ||
4 | Read the left wheel angle in the spinning base scale (internal part of the curve) | If there is a deviation regarding the nominal value, the wheel stopper should be adjusted on the left wheel. | |
Vehicle 634.081Maximum steering angle | |||
Vehicles 634.011/012/014/061/071Maximum steering angle | |||
5 | Turn the steering wheel to the right until the stopper and keep it in this position | ||
6 | Read the right wheel angle in the spinning plate (inner side of the curve) | If there is a deviation regarding the nominal value, the wheel stopper should be adjusted on the right wheel. | |
Vehicle 634.081Maximum steering angle | |||
Vehicles 634.001/011/061/071Maximum steering angle | |||
Adjust | |||
7 | Loosen the stopper screw (1) counter nut (2) on the wheel to be adjusted and adjust distances by screwing or unscrewing | ||
8 | Repeat the angles inspection procedures to confirm the nominal measure | ||
9 | Tighten the wheel (1) stop screw counter-nut (2) |