Remove the axle without suspension brackets |
1 | Flexible hose |
2 | Front stabilizer |
3 | Screw |
4 | Screw |
5 | Steering bar |
B33.10-0005-05
| Remove/install | ||
1 | Chock the rear wheels and apply the parking brake | ||
2 | Loosen the front wheel nuts | ||
3 | Lift the vehicle and support spars on appropriated easels so that the wheels are free | ||
4 | Remove the front wheels |
| |
After a test drive, retighten the wheel nuts. | |||
5 | Disconnect brakes flexible hose (1) | Seal the ends of the hose, to prevent dirt from entering. | |
6 | Disconnect the steering bar (5) of the steering column |
| |
.Steering bar to the steering arm | |||
7 | Install axle removal device | Support the front stabilizer bar (2) in order to prevent all suspension components (suspension supports, bellows, shock absorbers, armatures) are sustained by the shock absorber. | |
Device for removal and installation of front axles EE-023. | |||
8 | Loose the end cover screws (3) | .Bracket fixing (base) of the spring bellows and shock absorber - front axle | |
9 | Loose the suspension support screws (4) | .Closing cap bolts (bellows base) | |
10 | Go down the axle and remove it carefully | Use: | |
11 | Install in reverse order | Installation: After the axle is installed, the vehicle should be subjected to a full turning angle and alignment adjustment. |