Remove/install stabilizer bar on rear axle

AR32.20-D-0315HA

Remove/install stabilizer bar on rear axle

18.4.12

3.4.12

Repair method changed over to installation of torsion bushings



Removing

 Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.

AS00.00-Z-0010-01A

1

Lift/jack up vehicle

AR00.60-D-1000H

2

Mark assembly position of rubber bushings (7) on stabilizer bar (6)

3

Remove screws/bolts (3)

 Should the link rods (2) also be removed, remove bolts (1).

4

Remove screws/bolts (4)

5

Take off torsion bar (6)

6

Remove rubber bushing (7) from stabilizer bar (6)

 Clean all parts, check for wear and replace if necessary Bushing points must be free of grease.



Install

7

Mount rubber bushing (7)

 Only use rubber bushing (7) for torsion bushing. Align rubber bushing (7) in the center between the markings.

8

Install clamps (5)

 Replace clamps (5) if bushing has not been changed over to torsion bushing. For easy mounting, wet the rubber bushing (7) on the outside.

9

Align bushing

 Adjust bushing so that the contact surfaces at the frame are parallel to the stabilizer bar arms.

10

Position stabilizer bar (6) on frame

 Only turn the bolts (4), do not tighten.

11

Adjust basic setting of stabilizer bar (dimension a)

 For doing this, calibrate angle gauge at contact surface on frame to 0°.

*BE32.20-N-1001-06A



*001589882100

12

Tighten clamps (5)



*BA32.35-N-1004-03B

13

Install stabilizer bar (6) on the link rods (2)



*BA32.35-N-1005-03B

Number

Designation

Model
906.132/134/136

BE32.20-N-1001-06A

Assembly position

Rear axle torsion bar

Dimension "a"

°

81,9

See picture

AR32.20-D-0315H

Number

Designation

Model
906.1 with rear axle 741.417

BA32.35-N-1004-03B

Bolt/nut, stabilizer bar

M10 10.9

Nm

54

BA32.35-N-1005-03B

Bolt/nut, link rod

M10 10.9

Nm

54