AR27.19-S-4980S | Remove/install pilot bushing of electrohydraulic controller unit | 22.4.09 |
TRANSMISSION 722.6 in MODEL 636, 639.601 /603 /605 /701 /703 /705 /711 /713 /811 /813 /815
S27.10-4509-09
1 Oil pan
2 Oil filter
3 Pilot bushing
4 Screw
5 Electrohydraulic controller unit
6 Screw
Modification notes
| Remove/install | ||
Danger! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | |
1 | Switch off ignition | Withdraw ignition key. | |
2 | Remove rear engine compartment paneling | Only model 636, Perform on model 639.7/8 as of vehicle identification number (VIN) 055347. | |
3 | Disconnect electrical plug | ||
4 | Remove bolt (6) from pilot bushing (3) | | |
5 | Remove pilot bushing (3) from electrohydraulic controller unit (5) | When pulling out the pilot bushing (3) pay attention to transmission oil which runs out. | |
Installation: Replace sealing rings. | |||
6 | Install in the reverse order | ||
| Checking | ||
7 | Check transmission oil level, correct if necessary | ||
8 | Check transmission for leaks | Carry out a visual inspection only. |
Electrohydraulic controller unit
Henviste dokumenter
- ar2700s0101s
- ar2710s050001sv
- ar6120s110503s
- as0000z001001a Livsfare, hvis køretøjet glider ned fra eller tipper på liften.