1 | Oil pump gear (powered) |
2 | Oil pump gear (driven) |
3 | Oil pump housing |
4 | Shim |
5 | Valve element (on vehicles with transmission cooling) |
6 | Valve element (on vehicles without transmission cooling) |
Pfeil A | Roll pin (on vehicles with transmission cooling) |
W26.55-1054-06
1 | Oil pump gear (powered) |
2 | Oil pump gear (driven) |
3 | Oil pump housing |
5 | Valve element (on vehicles with transmission cooling) |
14 | Roll pin |
Pfeil A | Roll pin (on vehicles with transmission cooling) |
Pfeil B | Mark |
W26.55-1056-11
| Remove | ||
1 | Remove rear end cover | ||
2.1 | Remove valve element (5) | On vehicles with transmission cooling | |
2.2 | Remove valve element (6) | On vehicles without transmission cooling | |
| Install | ||
3 | Determine shim (4) for oil pump | ||
Play of oil pump | |||
4 | Place determined shim (4) on oil pump housing (3) | The roll pin (14) of the oil pump housing (3) must engage in the blind hole bore in the transmission housing. | |
5 | Lubricate and Install and oil pump gears (1, 2) | The markings (arrows B) on the oil pump gears (1, 2) must point toward the rear end cover. | |
6.1 | Install valve element (5) | On vehicles with transmission cooling | |
Replace O-rings. | |||
The roll pin (arrow A) of valve element (5) must be in a "9 o'clock position". | |||
6.2 | Install valve element (6) | On vehicles without transmission cooling | |
Replace O-rings. | |||
7 | Install rear end cover |