ar1322p1202va

Remove, install poly V-belt

Type ar · emne 13.22 · version 0103 · 2008-02-26

Gælder for: ENGINE 272 in MODEL 171

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 13 Kompressor, remtræk › 13.22 Enkeltremstræk — Serie 171

EinPAS 15 Motor › 15.18 Remtræk › 15.18.30 rem/remskive/spændeanordning/styrerulle — Serie 171

Gælder også for motorer/gearkasser: 272 ***

AR13.22-P-1202VA

Remove, install poly V-belt

12.4.06

ENGINE 272 in MODEL 171

Remove, install poly V-belt

P13.22-2082-07

Shown on engine 272.963 with transmission 722.906

4 Hexagon

5 Tensioning pulley

1 Front engine cover

2 Intake air duct

3 Poly-V-belt

Remove

1

Open engine hood

AR88.40-P-1000V

2

Remove front engine cover (1)

Pull out the front engine cover (1) from the mounts.

3

Remove left and right intake air duct (2)

4

Loosen and remove the poly-V-belt (3)

For this purpose, use the hexagon (4) and swivel the tensioning pulley (5) in a clockwise direction (arrow).

Take off the poly-V-belt (3) and decelerate the tensioning pulley (5).

Check

5

Inspect belt pulley tread pattern, belt pulley sections and tensioning device for damage and dirt, replace if necessary.

6

Check poly-V belt (3) and replace if required

Check poly-V-belt in visible area for wear

AP13.22-P-1352VA

Install

7

Fit on poly-V-belt (3), then clamp

For this purpose, use the hexagon (4) and swivel the tensioning pulley (5) in a clockwise direction (arrow).

Fit on poly-V-belt (3) and slacken the tensioning pulley (5).

Fit on poly V-belt (3) as specified in the running diagram:

Routing diagram of poly V-belt

AR13.22-P-3902-02VA

Do not use wax or similar products, as this may cause poly-V-belt (3) to slip.

8

Install the left and right intake air duct (2)

9

Install front engine cover (1)

10

Close engine hood

AR88.40-P-1000V

Henviste dokumenter