ar1322p1202v

Remove, install poly V-belt

Type ar · emne 13.22 · version 0102 · 2008-02-26

Gælder for: ENGINE 271 in MODEL 171

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 13 Kompressor, remtræk › 13.22 Enkeltremstræk — Serie 171

EinPAS 15 Motor › 15.18 Remtræk › 15.18.30 rem/remskive/spændeanordning/styrerulle — Serie 171

Gælder også for motorer/gearkasser: 271 ***

AR13.22-P-1202V

Remove, install poly V-belt

12.4.06

ENGINE 271 in MODEL 171

Remove, install poly V-belt

P13.22-2079-07

1 Engine intake air duct

2 Poly-V-belt

4 Tensioning pulley

3 Torx cutout

Remove

Danger!

Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof.

Keep body parts and limbs well clear of moving parts.

AS00.00-Z-0011-01A

1

Open engine hood

AR88.40-P-1000V

2

Remove engine intake air duct (1)

3

Remove wideband silencer

AR09.41-P-6825V

4

Loosen poly-V-belt (2) and remove

For this purpose, use the torx cutout (3) and swivel the tensioning pulley (4) in a clockwise direction (arrow).

Take off poly V-belt (2) and loosen tensioning pulley (4).

Check

5

Inspect belt pulley tread pattern, belt pulley sections and tensioning device for damage and dirt, replace if necessary.

6

Check poly-V belt (2) and replace if required

Check poly-V-belt in visible area for wear

AP13.22-P-1352V

Install

7

Fit on poly-V-belt (2), then clamp

For this purpose, use the torx cutout (3) and swivel the tensioning pulley (4) in a clockwise direction (arrow).

Fit on poly-V-belt (2) and loosen the tensioning pulley (4).

Fit on poly V-belt (2) as specified in the running diagram:

Routing diagram of poly V-belt

AR13.22-P-3902-02QP

Do not use belt wax or any similar products.

8

Install wide band silencer

AR09.41-P-6825V

9

Install engine intake air duct (1)

Henviste dokumenter