Serier
da
ar0941g2007dd
Remove/install boost pressure/charge air temperature sensor
Type ar · emne 09.41 · version 0102 · 2019-10-04
Gælder for: Engine 900.91/92 in model 000.001 Engine 902.91/93 in model 000.001 Engine 924.91/93/94 in model 000.001 Engine 925.9 in model 000.001 Engine 926.91/92/93/95/97/98 in model 000.001
Ikke tilgængelig på “da”; vises på Engelsk.
Placering
Funktionsgruppe 1 Motor › 09 Luftindsugning, luftladning › 09.41 Ladeluftrør/ladeluftkøling — Serie 000 (modeller 001) · Serie 900 (modeller 91*, 92*) · Serie 902 (modeller 91*, 93*)
EinPAS 15 Motor › 15.30 Luftindsugning/opladning › 15.30.12 Sensor/kontakt/ledningssæt — Serie 000 (modeller 001) · Serie 900 (modeller 91*, 92*) · Serie 902 (modeller 91*, 93*)
Gælder også for motorer/gearkasser: 924 91*, 924 93*, 924 94*, 925 9**, 926 91*, 926 92*, 926 93*, 926 95*, 926 97*, 926 98*
AR09.41-G-2007DD
Remove/install boost pressure/charge air temperature sensor
21.08.2019
Engine
900.91/92 in model 000.001
Engine
902.91/93 in model 000.001
Engine
924.91/93/94 in model 000.001
Engine
925.9 in model 000.001
Engine
926.91/92/93/95/97/98 in model 000.001
Shown on engine 900.9 with BlueTEC 4 (Euro IV Standard)
1
Electrical connector
3
Charge-air distributor
4
Charge air pressure and temperature sensor
2
Cap
Remove/install
1
Switch off ignition.
2
Take off cover cap (2) on charge-air distributor (3).
3
Disconnect electrical connector (1).
4
Remove charge air pressure and temperature sensor (4).
Installation: Clean sealing surfaces.
Screw/bolt, pressure and temperature sensor to charge air distributor
*BA09.41-N-1009-01I
5
Install in the reverse order
Charge air pipe/charge air cooling
Number
Designation
ENGINE 900.9, 902.9, 904.9, 924.9
Engine 906.9, 925.9, 926.9 in model 000.001
BA09.41-N-1009-01I
Screw/bolt, pressure and temperature sensor to charge air distributor
Nm
10
10
