ar0941g2007dd

Remove/install boost pressure/charge air temperature sensor

Type ar · topic 09.41 · version 0102 · 2019-10-04

Applies to: Engine 900.91/92 in model 000.001 Engine 902.91/93 in model 000.001 Engine 924.91/93/94 in model 000.001 Engine 925.9 in model 000.001 Engine 926.91/92/93/95/97/98 in model 000.001

Where it sits

Function group 1 Engine › 09 Air intake, turbocharging › 09.41 Charge air pipe/charge air cooling — Series 000 (models 001) · Series 900 (models 91*, 92*) · Series 902 (models 91*, 93*)

EinPAS 15 Engine › 15.30 Air intake/charging › 15.30.12 Sensor/switch/wiring harness — Series 000 (models 001) · Series 900 (models 91*, 92*) · Series 902 (models 91*, 93*)

Also applies to engines/gearboxes: 924 91*, 924 93*, 924 94*, 925 9**, 926 91*, 926 92*, 926 93*, 926 95*, 926 97*, 926 98*

AR09.41-G-2007DD

Remove/install boost pressure/charge air temperature sensor

21.08.2019

Engine	900.91/92 in model 000.001
Engine	902.91/93 in model 000.001
Engine	924.91/93/94 in model 000.001
Engine	925.9 in model 000.001
Engine	926.91/92/93/95/97/98 in model 000.001

Remove/install boost pressure/charge air temperature sensor

G09.41-3179-08

Shown on engine 900.9 with BlueTEC 4 (Euro IV Standard)

1	Electrical connector		3	Charge-air distributor		4	Charge air pressure and temperature sensor
2	Cap

 	Remove/install
1	Switch off ignition.
2	Take off cover cap (2) on charge-air distributor (3).
3	Disconnect electrical connector (1).
4	Remove charge air pressure and temperature sensor (4).	 Installation: Clean sealing surfaces.
		 Screw/bolt, pressure and temperature sensor to charge air distributor	*BA09.41-N-1009-01I
5	Install in the reverse order

 Charge air pipe/charge air cooling

Number	Designation		ENGINE 900.9, 902.9, 904.9, 924.9	Engine 906.9, 925.9, 926.9 in model 000.001
BA09.41-N-1009-01I	Screw/bolt, pressure and temperature sensor to charge air distributor	Nm	10	10