Remove/install air intake pipe

AR09.10-P-8131MR

Remove/install air intake pipe

19.1.15

ENGINE

274 in MODEL 204, 207

Modification notes

14.1.15

Replace shim ring on ATL, added

Operation step 9

1

Engine cover

2

Engine air intake duct

3

Hose clamp

4

Air intake pipe

5

Vent line

6

Engine wiring harness

7

Hose clamp

B28/5

Pressure sensor downstream of air filter

R39/2

Wide open throttle operation vent line heater element

 Danger !

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

 

Remove/install

1

Remove upper engine cover (1)

2

Remove engine air intake duct (2)

3

Unfasten hose clamp (3) and detach air intake pipe (4) on air filter housing

4

Detach vent line (5) on air intake pipe (4)

5

Detach wide open throttle operation vent line heater element (R39/2) on air intake pipe (4)

6

Unclip engine wiring harness (6) at air intake pipe (4)

7

Disconnect electrical connection at pressure sensor downstream of air filter (B28/5)

8

Unfasten hose clamp (7) and detach air intake pipe (4) at ATL and remove upwards

9

Detach compensating ring between air intake pipe (4) and ATL on ATL

 Installation: The compensating ring must be replaced after every disassembly.
The installation of the new compensating ring should be take place in the cleaned fitting of the air intake pipe (4) and not on the fitting of the ATL. The inside diameter of the compensating ring as well as the fitting of the ATL must be wet well with lubricant before assembly.

Lubricant

*BR00.45-Z-1032-06A

10

Install in the reverse order

Repair materials

Number

Designation

Order number

BR00.45-Z-1032-06A

Lubricant

A 000 989 08 60