ar0704p0007tk

Remove/install exhaust back pressure sensor

Type ar · emne 07.04 · version 0205 · 2010-11-12

Gælder for: ENGINES 642 in MODEL 207, 211, 212, 218

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 07 Blandingstilberedning › 07.04 Følere, sensorer — Serie 207 · Serie 211 · Serie 212 · Serie 218

EinPAS 15 Motor › 15.40 Udstødningssystem/udstødningsefterbehandling › 15.40.12 Sensor/kontakt/ledningssæt — Serie 207 · Serie 211 · Serie 212 · Serie 218

Gælder også for motorer/gearkasser: 642 ***

AR07.04-P-0007TK

Remove/install exhaust back pressure sensor

27.10.10

ENGINES 642 in MODEL 207, 211, 212, 218

Remove/install exhaust back pressure sensor

P07.04-2469-04

1 Plug connection

B60 Exhaust back pressure sensor

Remove/install

Danger!

Risk of injury to skin and eyes caused by handling hot or glowing objects.

Wear safety gloves, protective clothing and safety glasses, if necessary.

AS00.00-Z-0002-01A

Danger!

Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof

Keep body parts and limbs well clear of moving parts.

AS00.00-Z-0011-01A

1

Open engine hood and raise to vertical position

Model 218

Model 207, 212

AR88.40-P-1000EW

Model 211

AR88.40-P-1000T

2

Remove engine trim panel

Installation: Ensure correct seating of the engine cover.

3

Disconnect connector (1) on exhaust back pressure sensor (B60)

4

Remove exhaust back pressure sensor (B60)

*BA07.04-P-1005-01G

5

Install in the reverse order

6

Read out and erase fault memory using STAR DIAGNOSIS

Stored faults which may be caused by assembly work, test work, removed lines or a simulation, must be processed and erased in fault memories after completing the work.

AD00.00-P-2000-04A

Sensors

Number

Designation

Engine
642 without particle filter

Engine
642 with particle filter

BA07.04-P-1005-01G

Exhaust back pressure sensor on exhaust gas recirculation pipe

Nm

25

25

Henviste dokumenter