1 | Bolt |
2 | Timing case |
3 | Guide pins |
4 | Crankcase gasket |
5 | Bolt |
6 | Crankcase |
7 | Retainer |
8 | Engine flywheel |
B15 | Camshaft position indicator sensor |
M1 | Starting motor |
W01.60-1014-06
| Remove/install | ||
1 | Remove the engine |
| |
Type 958.2 | |||
2 | Install the engine on the assembly stand | Use an appropriate bracket. | |
3 | Remove starter (M1) | .Starter bolt to timing case | |
4 | Remove crankcase (6) |
| |
5 | Remove engine flywheel (8) | Remove/install a flywheel | |
Vehicles with mechanical transmission. | |||
6 | Remove the bracket from the sprocket | Vehicles with automatic transmission. | |
7 | Disassemble peripheral parts on timing case (2) | ||
8 | Remove holder with electrical harness on timing case (2) | ||
9 | Remove camshaft position indicator sensor (B15) | Installation: Push sensor until tightening sleeve stop and the camshaft position indicator sensor (B15). | |
10 | Remove retainer (7) |
| |
Install: Only install the retainer (7), when the timing case (2) is installed on the crankcase. | |||
11 | Remove the timing case (2) | If necessary, loosen the timing case (2) with a rubber hammer. | |
Installation: Check timing case (2) for damages, if necessary replace it and transfer all its components. | |||
Engine 904.9, 906.9Distribution housing to the block | |||
12 | Clean the sealing surfaces | Installation: Apply a sealing compound. | |
Sealant Loctite 574, 50 ml | |||
13 | Install in reverse order |