AR01.00-P-3050RR | Release, position rear drive module | 18.2.03 |
ENGINE 160.921 /922 /923 in MODEL 452.3 /4
P01.00-2368-01
1 Tie strap
2 Main wiring harness
3 Air filter box
4 Ground strap tie strap
5 Charge air pipe
P01.00-2369-04
6 Air intake funnel
7 Spreading clips
P01.00-2370-07
8 Hand brake cables
9 Pin
12 Rear bolts
10 Folding clamp
11 Front bolts
13 Bolts
P01.00-2620-03
| Remove/install | ||
1 | Remove bolts (13) | | |
2 | Remove engine compartment cover | ||
3 | Remove tie strap (1) of the main wiring harness (2) at air filter box (3) | Installation: Replace tie straps (1). | |
4 | Detach ground strap cable tie (4) to charge air pipe (5) | Installation: Install new tie straps. | |
5 | Unscrew nuts at left rear wheelhouse cover | ||
6 | Pull out left rear wheelhouse cover | ||
7 | Detach air intake funnel (6) | Remove spreading clips (7) | |
8.1 | Loosen low-temperature water cooler | Only for engine 160.923. | |
| |||
| |||
9 | Remove rear underbody paneling | ||
10 | Unclip handbrake cables (8) at bottom at traction cable rocker | ||
11 | Unscrew bolts (9) of clamp (10) for brake and speed sensor line fastener and open clamp (10) | ||
12 | Unclip brake and speed sensor line from the clamp (10) | ||
13 | Position main lifter with removal fixture at rear drive module | Risk of damage to oil cooler! | |
Removal fixture | |||
Base jack | |||
Base jack | |||
14 | Unscrew front bolts (11) and rear bolts (12) on body | The rear bolts (12) are longer. | |
Installation: Observe tightening sequence (front left, front right, rear left and rear right). | |||
The bolts at the front (11) and bolts at the rear (12) must also be replaced when replacing the vehicle body. | |||
15 | Screw in the release bolts in the bore holes of bolts at the front (11) and bolts at the rear (12) | Just screw in release bolt by hand up to the threaded tappet, do not tighten, otherwise damage to the thread will occur. | |
Screw in the two longer release bolts at the rear. | |||
Set of release bolts | |||
16 | Slowly release rear drive module | When lowering, ensure adequate clearance is provided. | |
| |||
17 | Install in the reverse order |
Charge air cooler water cooled
Number | Designation | Engine | ||
BA09.41-P-1006-03B | Nut connecting bracket to rear underfloor paneling | Nm | 2 | |
BA09.41-P-1007-03B | Nut connecting bracket of low temperature water cooler to clamping plate | Nm | 10 | |
Rear axle carrier
Number | Designation | Model | |
BA35.10-P-1001-01F | Bolt connecting frame-type integral support to body | Nm | 100 |
CMS rear end
450 589 00 62 00
Set of release bolts
Removal assembly
450 589 01 62 00
Commercially available tools