1 | Elevation bellows |
2 | Arc |
B35.50-0001-01
| Check | ||
1 | Lift the rear drag axle | Only on unloaded vehicles. | |
2 | Visually inspect the lifting bellows (1) | Check for external damage (e.g. strains, cracks, cuts, friction points etc.) | |
In the case of damages/failures found: | |||
| |||
Replace the lifting bellows – with separate invoicing. | |||
| |||
3 | Check the arch (2) of the lifting system | Check for external damages and wear. The arcs wearing (2) can not exceed 2 mm. | |
In the case of damages/failures found: | |||
| |||
Remove/install the bellows of the rear drag axle hub. | |||
| |||
4 | Check all the other lifting system components | Check for external damages and cracks. | |
In the case of damages/failures found: | |||
| |||
Eliminate damages/failures – with separate invoicing. | |||
5 | Totally depressurize the rear drag axle lifting system | The vehicle must be unloaded and on a leveled surface. | |
6 | Check the clearance between the lifting system arcs (2) and the rear drag axle pipe | If the existent play does correspond to the prescribed value: | |
| |||
Adjust the arc (2) of the lifting system – with separate invoicing. | |||
| |||
"C" clearance between the arc and the axle tube housing |